Forum Replies Created
-
Posts
-
Re: neff micro H7871
Hi jimjam
It wasn’t a dig at you or your ability, its just that this being a public forum, it will be viewed a number of times and their ability may not be the same as you or I, you see?If you need trade access so we can advise further please contact admin@ukwhitegoods.com to facilitate that.
Thanks for your understanding
Greg
Re: neff micro H7871
Hi jimjam
Im sorry but we are unable to supply parts or advise on any repair which invloves working on it internally due to the high voltages stored within. 🙂Greg
Re: WHIRLPOOL AWZ7303 Condenser Tumble Dryer NO HEAT
o_ptic wrote:1) what is the best way to test the heater, I have a good voltmeter/ammeter to hand, what value should I be seeing, and
Best way is on its contacts approx 20-30 ohms and check the stats that feed it aswell, they should be 0 ohms if intact.
2) how do I gain access to the blower thermostat which I believe is at the front of the machine? and what is the best way to test also?
You are correct it is front right and is quite popular to blow.If it is intact you would be looking at 0 ohms. You will have to remove lower plinth to gain access.
Un plug appliance before attempting repair :plug:
Greg
Re: Neff Oven Door Broken
Hi
To fix this effectively you will need the following.
Door Outer 297523
Door-inner 436624
Hinge 260797
Hinge 260798
Hinge Bearing 172647I hope you are sitting down because you will be looking close to £300 for that lot 😯
An email to spares@ukwhitegoods.co.uk if you up for the job 😀
GregRe: bosch dishwasher water presure!
Hi
It must be at least 0.5 bar and no more than 10bar or a pressure reducing valve must be fitted 😀Greg
Re: Slow tonight?
Hi Kev
After what you just said I have come to the conclusion it may be the Norton Firewall as Sean and I both use it 😯 I have lowered the firewall setting and it seems quicker 😀Greg
Re: Bosch Logixx SGS0902GB/04 – Soapy residue remaining
Hi
The coding information should have been administered by the engineer after module installation.
As I previously statedI would therefore allow the engineer to return to assess to be fair.
as the job is obviously not correct and a return visit is necessary.
Regards
Greg
Re: hahaha
[HAL’s shutdown]
HAL: I’m afraid. I’m afraid, Dave. Dave, my mind is going. I can feel it. I can feel it. My mind is going. There is no question about it. I can feel it. I can feel it. I can feel it. I’m a… fraid. Good afternoon, gentlemen. I am a HAL 9000 computer. I became operational at the H.A.L. plant in Urbana, Illinois on the 12th of January 1992. My instructor was Mr. Langley, and he taught me to sing a song. If you’d like to hear it I can sing it for you.
😆 Greg
Re: Radio Programmes in Van/or Volvo/or Saab/or unicycle
kandl-appliancerepair wrote:I listen to Chris moyles and radio 1
Someone has to 😆
kandl-appliancerepair wrote:until about lunch time, then switch over to kerrang for some “hard rawk!”
Good call 😉 :whip:
Greg
Re: Slow tonight?
Its painfully slow has been for ages. Cant wait for new server 😀
My connection is fine so must be them yanks 😆Last Result:
Download Speed: 6644 kbps (830.5 KB/sec transfer rate)
Upload Speed: 373 kbps (46.6 KB/sec transfer rateGreg
😆