Forum Replies Created
-
AuthorPosts
-
gegsy
ParticipantRe: Bosch SGS5312GB/12 not emptying
Have you tried putting end of drain hose into bucket and see if it empties.?
That will eliminate the drainage system of the appliance.Greg
gegsy
ParticipantRe: Bosch SGS5312GB/12 not emptying
First post.
RodA wrote: I’ve blow compressed air into the sump outlet and it comes out of the drain hose so I know there’s no blockage in the outlet pipe.
Last post
RodA wrote:……I can see through the clear pipe that the waste water is not even getting to the waste outlet pipe?
Confused now. 😕
You can get a blockage in the drain outlet of the water matrix. This is behind the l/h panel. You will see which port it is as the drain hose attaches onto it. Remove that pipe and look carefully for silver paper etc that could obstruct the bore.
Power off before attempting and you will need to drain the matrix down before removing that pipe.
Please do not undertake any live testing as there really is no need. If the pump is pumping you will hear it 😉
Greg
gegsy
ParticipantRe: Bosch SGS59A22GB/17
Optical sensor faults are rare and usually down to crud on the faces which usually means a heater change.
Also the sensor calibrates itself after every wash. If a calibration cannot be done, then a permanently stored programme is executed and an error is saved in the module.HTH
Greg
gegsy
ParticipantRe: Bosch SGS5312GB/12 not emptying
Hi
Impeller should not be totally free, it should “twang” every quarter turn.
You seem to have checked everything else.
What about the physical plumbing the waste house goes into, is it clear ?Greg
gegsy
ParticipantRe: Whats the most annoying thing customers do?
…………. hot day, too nice to be working, customer chilling out with beer saying “Id offer you one but your driving, Ill get you a soft drink if you like ?” 👿 😥
Greg
gegsy
ParticipantRe: Neff 1031 (1051) timer module required.
Hi
Have a look at the rating plate, model possibly similar to B1120??GB/??Greg
gegsy
ParticipantRe: Bosch WFK5730GB/04
Dry joint on motor module?
Don’t have tacho readings sorry.Greg
gegsy
ParticipantRe: Bosch WTL6106gb/07 Fault codes
Its part no 163297, forgot to add 😀
Greg
gegsy
ParticipantRe: Bosch WTL6106gb/07 Fault codes
Hi
Possibly NTC R2 faulty. This one sits on top of heater bank 😉Greg
gegsy
ParticipantRe: Recommended Listening
Journey have been a solid group for me and the departure of Steve Perry was, at best worrying. Until …………………… Arnel Pineda arrived December 2007 😀
I swear to god its the same voice different guy 😆Anyway Journey lives on, there is a (Phillipino) god and he is Arnel 😉
Greg
gegsy
ParticipantRe: Euro 2008.
So erm Ronaldo couldnt prevent Portugal from getting the erm…..das boot from Euro 2008 😆
Greg
gegsy
ParticipantRe: Built in oven in a brick wall
I have seen a Neff in a wall, as it were. 😀
No problems providing you adhere to ventilation requirements as per manufacturers instructions.Ventilation is ventilation regardless of media.
Greg
gegsy
ParticipantRe: Euro 2008.
…………so thats two egg mayonnaise, a prawn Goebbels, a Herman Goering and four Colditz salads 😆
Greg :offtopic: 8)
gegsy
ParticipantRe: Euro 2008.
German woman…………good card players 😆 eh Fawlty
Greg
gegsy
ParticipantRe: indersit wi 101
Moved to Trade section 😉
Greg
-
AuthorPosts
