Forum Replies Created
-
Posts
-
Re: Miele D/W G1220SC error F014
Hi Ross
There is an extensive list of known error codes at the heading of this topic, please utilise this list, that has been gratefully updated by members; in the future first.
http://tinyurl.com/ptsno
RegardsGreg
Re: Prima LPR600
Remove card and re check that you have lined the buttons up correctly.
You should hear and feel a definate click when you press the start button.
Re check all the connections aswell.
If you get continuous flashing ie 1 flash 1 sec pause 1 flash etc usually means that the NTC is faulty.Greg
Power off before attempting any of the above :plug:
Re: module for HAIER HE 1400TXV
Chinese 😉
Washing machine I think Dave, still a lovely quality product 😛
Greg
Re: Wpl ADG934AV d/w
Hya Chris
Had some broken wires connecting the two pcbs before now.
BTW check yer emailGreg
Re: Bosch dishwasher hinges?
Hi
Nothing like a Bosch model number. They usually start “S” ending in /??Greg
Re: Leaking Whirlpool ART706 American Side by side FridgeFre
Hi Matty
In that bottom corner, there is usually a push to fit joint unit, which joins the feed pipe form the water valve to the uplift pipe to water dispenser. These sometime work loose and weep. Locate the unit and push both pipes fully home into the unit and test.Greg
Re: NEFF COOKER (FAN ELEMENT WIRES)
Hi Les
I don’t know colours but the wiring diagram for element is as follows.1/ One side of circotherm element, 2 wires together. One goes to temp limiter and the other goes to top element
2/ Other terminal, wire goes to Oven switchHope that helps
Greg
Re: Bosch Dw SRS 56A02GB/B
Hi Lawrence
This is a guide and you will probably find your own method, but this is the recommended way 🙂Unscrew outside door, base panel, angle strip and side panels. Disengage the tension cords from the hinge levers. Unscrew the screws which connect the base pan to the hinge plates. Unscrew the rinsing tank from the rear panel of the base pan. Disconnect the door cable harness from the plug-and-socket connection in the base pan. Place the appliance on its back, carefully remove the base pan and loosen the catch between the level sensor housing and the water softening system. Disconnect the circulation pump with the rubber support from the base pan. Open the base pan until the instantaneous water heater can be screwed off the pump sump. Unscrew the instantaneous water heater. Release the catch on the pump sump and lever the instantaneous water heater off the plug-and-socket connections of the pump sump / circulation pump.
Good luck
Greg 8)
Re: Boilers?
Hya GB
Unless you are Corgi mate I would leave well alone for obvious reasons.
Off the record it sounds to me like the thermostat. 😉
Greg
