Forum Replies Created
-
Posts
-
Re: Samsung Side by side fridge freezer problem
Expert are ceasing in a few months that is true, although they may get bought before then 🙂
Greg
Re: Miele G 646 SC PLUS – wash/drain cycle sticking
Like Penguin said its probably a leak in the drip tray, probably evaporates and allows flood float to lower for a few uses then off it goes again.
Greg
Re: Miele G 646 SC PLUS – wash/drain cycle sticking
Check l/h side uplift pipe which is connected from top of inline heater.This plastic pipe wears where it enters top of tank and leaks and overflows from top of tank to base in a stream, tell tale signs will be apparent.
Greg
Re: Bosch KGU3200GB f/f – fridge not working.
2 screws hold top fascia, remove;and PCB is the one horizontally situated facing you. It just pulls out , no wire 😀
Greg
Re: Servis Caress 900 Dryer Problem
ukez wrote:Are you talking about the white rectangle block bit with two spade terminals at the front of the machine just left of the main dials on the foiled air vent bit.
I noticed one wire looks like it has come off of one of the spade terminals and the other seems to have been rubbing on something, any suggestions?It only seems to have rubbed on the plastic surrounding the female connection on the one that stayed on. I dont see any rubbing signs on the one that is disconnected, is this a normal thing for this machine greg?
Thanks for your responses guys.
Thats the one, re attach/replace spade and test. Should be fine.
Greg
Re: Servis Caress 900 Dryer Problem
Hi
Check wire off pressure switch and amp tag/burnt off wire to limiter rod stat at front right of dryer manifold 😉Greg
Re: Bosch KGU3200GB f/f – fridge not working.
Hi
Without doing any checks myself, it sounds like the PCB (situated in top of fascia) part number 263782, around the £100 mark and will need Vat and p&p added. Use link below to locate.Greg
Re: “Off topic” Unusual names of members
Phidom wrote:Odd, I tried it and didn’t get any music. 🙄
I wouldnt complain 😆
Greg
Re: Bosch washer enr:WFO2864GB/01
Hi
The NTC operating range is between –5 °C and 103 °C. If the NTC value is outside the operating range (e.g. interruption or short-circuit), the programme continues cold without an error display. The test programme displays “NTC short circuit” or “NTC interruption”. The NTC is inserted into the heating flange and is sealed with the heater seal. The NTC can be removed after desconnecting the heater. Temperature in °C
Resistance in kΩ
10 – 8.5–10.6
20 – 5.4–6.5
30 – 3.5–4.3
40 – 3–2.9
50 – 1.5–1.9
60 – 1.1–1.3
66 – 0.9–1.1
86 – 0.45–0.55Hope that helps
Greg
PS – NTC part number is 170961
