[gekko]

Re: F&P GW708U Noisy Bearings!

have reassembled mashine with new bearings and seal. it was easy to take apart but much harder to reassemble and would have been much easier with the correct tools. i have a fitting trade back ground and have changed many bearings so i felt confident enough to attempt this job. did my first load of washing but mashine did not pump out. read my topic “F&P GW708U not running flashing lights and beeping” for mor of the saga.

thanks gekko

[gekko]

Re: F&P GW708U not running flashigh lights and beeping

ok i have now reassembled the washing mashine after replacing the bearings and seal but as stated by you in a previous post “F&P GW708U Noisy Bearing!” it is a difficult job easy to take apart but harder to reassemble.
anyway have put on my fitrst load of washing on but the mashine will not pump out and i get a beep code which is, counting from right to left the 1st, 3rd, 6th lights are on the rest are off, can you please assit with this code.

thanks gekko

[gekko]

i have just removed my bearings and seal because of the noise i mentioned. on removal found seal worn therefore bearing had water in them and were very corroded which made the washing mashine sound like a jet taking of on spin cycle.have ordered new kit which includes 2 bearing and 1 seal . part nuber for this kit is “425009 kit” i orderd the kit from http://albury.net.au cost aproximatly au$42. when i recive parts and install them i will tell you if it worked .

[gekko]

i have just removed my bearings and seal because of the same noise. using a hamer and drift oops:). on removal found seal worn therefore bearing had water in them and were very corroded which made the washing mashine sound like a jet taking of on spin cycle.have ordered new kit which includes 2 bearing and 1 seal . part nuber for this kit is “425009 kit” i orderd the kit from http://albury.net.au cost aproximatly au$42. when i recive parts and install them i will tell you if it worked .

[gekko]

Re: F&P GW708U not running flashigh lights and beeping

i just went and tried the washing mashine it came up all clear, so i will do a few loads of washing with it and see how it goes. On another note are the motors interchangeable between the 709 and 708 ? i will keep you posted on the results
thanks gekko

[Author]

Posts