[gergswin]

Re: Hoover DST10146P overfilling

Try clipping of the ends of the pressure pipe, about 1cm at each end then connect back with the spring clips,The pipe will then fit tight.
let me know how you go on.

[gergswin]

Re: Hoover OPH714D

Ok mate,I work for Hoover though and come across this problem a lot ,we had a memo through for the false e03 error when heater low insulation

[gergswin]

Re: Hoover OPH714D

E016 is dispersion from the heater, on this model it can also bring up an e03 drain issue which isn’t actually the fault. Replace heater, check for lime scale build up also

[gergswin]

Re: Hoover Dynamic 9+6 washer dryer

More than likely one of the two red wires from the sensor has come loose, if you take off the lid after unplugging of course you will see the w/d exhaust the sensor nearest the front of the machine will have a loose connection or complete disconnected

[gergswin]

Re: Hoover Dynamic 8+ error code 1

Motor fault,either the tacho on the motor is faulty or it could be just simply the brushes,if it’s the tacho the motor will need replacing.

[gergswin]

Re: Hoover washer dryer wdyns654 – please help!!!

Ring up Hoover candy as the machine is new they will repair it free of charge under the 12 month warranty

[gergswin]

Re: Candy GRAND GO 292-80

Sounds like it could be the pressure switch.

[gergswin]

Re: Bosch Exxcel 1200 drum not turning

Take off the brushes and clean the armature, Use light sandpaper push against armature and spin the motor from the shaft until its clean,then refit brushes if that does not work it’s a new motor you need

[Author]

Posts