Forum Replies Created
-
Posts
-
Re: Whirlpool ADG7550 not heating
It was a broken wire between the control board and the heater.
The wire was broken near the bottom of the door where it gets flexed all the time.
GrantRe: Whirlpool ADG7550 Service Manual
It was a broken wire between the control board and the heater.
The wire was broken near the bottom of the door where it gets flexed all the time.
GrantRe: Whirlpool ADG7550 Service Manual
Ran the machine last night. Still no hot water.
It gets a fault code 3.
Where do I start ?
Regards
GrantRe: Whirlpool ADG7550 Service Manual
It’ll be the first thing I’ll check once I get into the thing.
I don’t have a Torx 15 driver yet. I need to get one.
Thats why I asked if there was a service manual to see where 1. the heater is.
2. the temp sensor is
3. And if there is a thermal fuse.
I wasn’t sure if these things would be at the bottom? at the back?, and will I need to fully remove the dishwasher as its built in etc.
Any advice, or a manual would be much appreciated.
I’ve had trouble on and off with the temp sensor (fault code 1) for a while but it seemed to clear. Now it just doesn’t heat the water.
Regards
Grant
