Forum Replies Created
-
Posts
-
Re: Dishwasher Recommendation
Cheers don you suggested that before and Iv had a good look round and it looks a good one. I did find an AEG which came with a 5 year warranty but when I tried to order it it it was no longer in production! Other than that I think I will get the one you mentioned.
Re: Built in dishwasher for £300 suggestions please
Thanks don will keep that in mind when I look around in the next few weeks
Re: Built in dishwasher for £300 suggestions please
Any models to look out for or any thing made by them?
Re: Hoover HC6-145m door lock faulty
No it wont do anything as the lock light wont come on. I’m thinking of buying the lock module mainly as its the cheapest fix! first and see how it goes.
Re: Hotpoint WD440 washer dryer flashing lights
Can some one give me a link to where I could get one of these NTC’s thanks
Re: Hotpoint WD440 washer dryer flashing lights
What is an NTC and where is it?
Can I test it?
Could it be a thermistat?Re: Hotpoint WD440 washer dryer flashing lights
Iadom the top two on the left side are flashing and the 4th one down as well. Any ideas?
Its a secondhand one I’m not sure how old it is and whether its still under warrentyRe: MFI fridge freezer problem help
Sorry for confusion the freezer is fine but the fridge seems warm. I’ll try what you suggested and get back.
Re: MFI fridge freezer problem help
Dales electrical thanks for the reply. The serial number I think is 20043115444-03813003-03
Any ideas why the fridge seems warmer than normal?Re: Hotpoint WD860… no end of trouble
Iv got the same problem but cant seem to find the solution.
1. Iv replaced the thermostat the resistance across the pins is 24kohms. Both the new one and old one measure the same resistance so Im assuming they are infact ok but please let me know if this is wrong?
2. Iv tested the heating element and it reads 46ohms across the connetions which shows its not open circuit. During drying cycle the voltage to the element is 68volts but not sure if this is correct.
3. The fan is spinning and I have removed the whole assembly and dont remember the fan being loose.Iv had a good look around and cant seem to find anything. I’m just woundering if it is the element as there is volatge going to it but it does not heat up.
Some help before my wife kills me!!!!!!! 😥 😥
