[handyman270470]

Re: Hotpoint FFFM 180 Air Tec Evolution – Fridge /Freezer-

Hi Kwatt,
Thank you for your reply.

I will check the tempearture by placing the thermometer and take it from there.

I will check the continuity of the Low voltage fan motor.

So i will investigate and take it from there.

Thank again.

[handyman270470]

Re: Hotpoint FFFM 180 Air Tec Evolution – Fridge /Freezer-

Another Close up picture of the back compressor

[handyman270470]

Re: Hotpoint FFFM 180 Air Tec Evolution – Fridge /Freezer-

Hi Kwatt,
Thank you for your reply.

I am sure it is pretty cold, as the food is well freezed and and you can tell the freezer is working, as you can see it has frost and cold.

I do not Know the Temperature of the freezer, unless if i place a thermometer to measure the temperature.

So you suspect fan motor, sensor, or the compressor.

I can here the compressor kicking in when i take the plug off, so this might be serving the freezer only.

How do i check the fan motor, sensor and the compressor, as i have the multimeter to check the fan motor componenet, but i am not sure about the sensor or the compressor.

I do not understand what you mean by this point ? (You’d need to prod about a bit to find out.)

[handyman270470]

Re: Hotpoint FFFM 180 Air Tec Evolution – Fridge /Freezer-

Freezer compartment picture.

[handyman270470]

Re: Hotpoint FFFM 180 Air Tec Evolution – Fridge /Freezer-

Another picture

[handyman270470]

Re: Sharp Microwave R-345 MODEL ,FUSE OK, BUT NO POWER

Thank you for your reply.

Foil wrapping was a temporary to test the microwave to check if the fuse is gone, however i tested the fuse is working and microwave was working.

I check with Multimeter, but i make sure the power is disconnected and wait a few minute to discharge any other power left.

I am replacing the fuse like for like.

By the way i was in the trade in Plumbing craft 603/1, but i do not do it anymore due to health reason and knees are knackered, as i can not not kneel down on the floor long time.

However i wanted to know what could of gone wrong in the microwave for the fuse to blow, so i wanted to check the components of the microwave from the Mulitmeter and i will only make a decision or check if i am confident and competent to do so, as i do not want to kill myself or others, as safety is my first priorty.

Like i said if i am not capable then , i would not touch it 🙂

[Author]

Posts