[harry12]

god bless you electrofix ,

cooker restored all working it was terminal 5 to the control module

[harry12]

opss sorry its a (948905054-00)

[harry12]

Re: hotpoint wma 34 wma series expert advice bearings

ok after hammering wd4o ing paitence blowtouching drilling taking advice off you geniuses the machine is up and running and very quite on full spins.

it took me well over 3hrs altogether. but well worthj the DIY

ONCE AGAIN THANKS YOU GUYS TOPS FORUM! 😆

[harry12]

Re: hotpoint wma 34 wma series expert advice bearings

ok looking at the shaft the rod on the spider all looks clean not damage spider has no rust or cracks/

will this be ok

and just do bearings the rods looks good

[harry12]

Re: hotpoint wma 34 wma series expert advice bearings

how can i remove the drum shaft or is it the the whole drum

is it the nut at the top or

the spider comes out then how does the shaft get lose

[harry12]

Re: hotpoint wma 34 wma series expert advice bearings

ok here goes guys

i wd40 the thing nearly emtyed the bottle left it over knight

blow tourch the inner bearing and wacked it out with a concreate chisel did the job

know to sand the edges down on drum clean everthing up and put bearings
in!

any advice on putting in new bearings in ie how and what with and any known method?

[harry12]

Re: hotpoint wma 34 wma series expert advice bearings

@martin

thanx m8 loads of wd40 leaving it for few hrs with hammering intervals did the job.

imagin 19 stones comming down on the shaft over six times that did it though but need a new spider got the bearings

the outer half how should it look with all bearings out

i done it but think i still need som bits out of the hole

[Author]

Posts