Forum Replies Created
-
Posts
-
Re: Brandt cooker hood AD689XE11
Can’t upload photos, but a very similar model – Brandt AD589X1 – is on view here:
http://www.ubaldi.com/electromenager/cu … 610404.phpRe: Brandt cooker hood AD689XE11
Not unusual in France. I will try to post the installation instructions and a photo. The main question is: when the chimney surround is removed, does this give access to the controller card, or must I take the whole works off the wall and disassemble to get to the card?
Re: Brandt cooker hood AD689XE11
Worse than that, unfortunately: the wall cupboards were installed after the hood, and the chimney cannot be removed unless the adjacent cupboards are as well. It is for this reason that I hope someone with an intimate knowledge of this model can advise if the duff card can be accessed from within the casing of the extractor fan, rather than disassemble the whole thing. The eight strand communication cable between the switch bank and the card disappears through a hole in what I can only describe as the “ceiling” of the fan enclosure, but I cannot see any means of removing this panel, to access the card. Any ideas? Thanks.
