[hughiep]

Re: Hotpoint Aqualtis AQGMD 129

Hi, got some useful info from the discussion above, had an f13 fault on my AQGMD 129 recently too. What sorted mine was, after taking the top off, I noticed a broken wire which I repaired. It was coming from a temp sensor (?) on the rhs of the big metal duct-like thing above the drum on the rhs of the machine. As always, disconnect from the mains before exploratory surgery. It looked like the wire may have been strained by the spin action so leave some slack if you find you have to repair it. Btw, taking off the top: remove the 2 screws at the back then gently lift from the back, pulling back as you go, should ease off nicely. Shouldn’t have to force, remember, the force is for star wars. Good luck.

[Author]

Posts