Ishtar

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Recommendations please – need a new fridge-freezer #344632
    Ishtar
    Participant

    Re: Recommendations please – need a new fridge-freezer

    Thanks Don
    Found a Hotpoint – very good deal, one that I couldn’t pass up!
    Cheers
    D.

    in reply to: Miele G975SC – noisy when filling/drying #327853
    Ishtar
    Participant

    Re: Miele G975SC – noisy when filling/drying

    Sorry to take up forum space…This has now been solved.

    I took the outlet pump assembly apart, cleaned, and found a foreign object (cherry pip 😳 ) in the impeller.

    Thanks for looking.
    Kind regards
    Diana

    Ishtar
    Participant

    Re: NEFF Fan Oven – need help finding instruction manual

    Hi Don
    Thanks for your help – I’ll give Neff a call tomorrow morning and see if I can get hold of an instruction manual.
    Thx
    D.

    in reply to: Zanussi DE6850 – Not draining #203724
    Ishtar
    Participant

    Re: Zanussi DE6850 – Not draining

    Thanks a lot! We’ve just been looking around a couple of websites and Bosch seem to be very popular.

    Not sure we can stretch to a Miele, but would be lovely…

    Cheers
    D.

    in reply to: Zanussi DE6850 – Not draining #203722
    Ishtar
    Participant

    Re: Zanussi DE6850 – Not draining

    Thanks for the reply – I think the problem might be more terminal as I cannot even run a rinse program. Power on/off switch works, but no others. Have checked the obvious, no blockage at the sink end, so clearly an issue within the machine.

    Quite honestly, with all the possible solutions, and in the light of the fact that this is the third problem in the last 10 months, I think we’re off to buy a new one!

    Any recommendations?!

    Many thanks
    D.

    in reply to: Zanussi DE6850 #174451
    Ishtar
    Participant

    Re: Zanussi DE6850

    Have looked at the PCB and it is pretty obvious that this is where the fault lies as there is a bit(!) of a scorch mark 😯 . Anyhow, the problem seems to be a dry solder joint, which we can fix. Hopefully the relay hasn’t suffered as well….

    Thanks a lot for your help – sounds mad but without this site we wouldn’t even have looked for the problem, just called out an engineer.

    Cheers

Viewing 6 posts - 1 through 6 (of 6 total)