Forum Replies Created
-
Posts
-
Re: indesit omega 1200
hi all, thanks for your help so far….
this is what i have done so far….
checked motor, it works during the rest of the cycle but not spin.
dismantled the brushes, they look servicable, about 3/4 inch long, plenty of wear left in them. no cracks or shells to the edges.
dhecked the pressure switch mechanism, when i blow and suck it clicks so its working ok.
cleared out the little sludge that was in the pressure switch pipe.
this is all that i can do i think. as everything else works and there is nothing left to check, can you guys think of anything else it could be apart from the module? if the module does need changing, is there any way i can visually inspect it to tell if it is not working?
cheers all…..
Re: indesit omega 1200
yes i do, in fact the one that the spin failed on was a boil wash….. any remedy?
Re: indesit omega 1200
Hi, the motor was the first thing i thought of but the drum still turns as it should while it is on a wash cycle… its not the motor…..
Re: indesit omega 1200
hi, thanks for your quick reply…. i have inspected the belts and all seem fine, tried a spin cycle yesterday and nothing at all happened apart from the pump emptying the water out, the point is the spin didnt happen; no funny noises, no start then stop….. i also did a rinse and spin but the same thing happened. the drum does turn on other cycles, its just the spin where it doesnt turn. i have been told that the pressure switch may be blocked and the machine may think there is too much water in hence the reason for it not spinning…? does that make any sense?
