[jackoho]

Re: Indesit W143

Thanks for all your help and advice. The problem has been resolved – much in part to your information and instructions. When i cancelled the programme i was able to move programme to spin. and this worked – so I knew the programme function was ok and it had to be the solenoid wiring which was the only other thing that had been touched. The wiring had been crossed and bingo – relief and wife back in communication mode. Now all the ironing awaits!!!!!!!!!!

[jackoho]

Re: Indesit W143

Thank you for your reply – I followed your advice without success. Can you advise why when only one of the two solenoids in the cold water feed fails the other dosn’t work. I ask because although they logically might appear to be in parallel – if I had mistakenly crossed over the wiring this could be the problem. (still dosen’t allow for the fact that the water fills for about a second – also is the “pressure sw/sensor ” part of the solenoid?

P.S. Don’t got any fault codes mch. just inactive but door functions operated but dosen’t now click around to default programme since I followed your instruction.

Thanks again for your advice. Can you come up with any other instruction or advise where I can procure a wiring diagram.

[Author]

Posts