JamboChris

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 21 total)
  • Author
    Posts
  • in reply to: Liebherr K2330 #464959
    JamboChris
    Participant

    The thermostat was open circuit all the time and was replaced. It is now working correctly. I still can’t see a coolplus button. Thanks for the pointers.

    in reply to: Liebherr K2330 #464958
    JamboChris
    Participant

    Tony R wrote:I would suspect the thermostat, providing the fridge is not in too cold an environment for the thermostat to switch the compressor back on after the auto defrosting it needs to be in a warm room. Switch on the CoolPlus function* At low room temperatures of 18 °C or lower: Press the Cool-Plus switch

    Thanks for the replies.
    The fridge is in a kitchen with a temperature of about 22 degrees.
    I can’t see a coolplus switch on the instructions or the picture she sent me, where is it?

    in reply to: Liebherr CUN 3031 not cooling #396927
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Hi again!
    I took the cover off the fan before defrosting and there was a large build up of ice on the pipes and evaporator. The freezer was left for a day and had fully defrosted.

    So far so good. The fridge dial is now on 4 out of 7 and the fridge stays between 3 and 5 degrees. The freezer lies between -21 and -25 (does that sound okay?)

    It sounds like the fan is running for longer/faster as previously when you opened the freezer door the fan stopped immediately. Now when you open the door, the motor stops but you can still see it spinning as it comes to a stop.

    Thanks ELDAR59 for your help :tup: with this saga and fingers crossed that is the end of my freezer woes. 🙂

    Chris

    in reply to: Liebherr CUN 3031 not cooling #396926
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    OK, will do.
    Thanks for your patience!

    in reply to: Liebherr CUN 3031 not cooling #396923
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Hi,

    I managed to order the PCB from Liebherr with a couple of white lies 🙂 It arrived first thing this morning and was fitted by 10am.
    My block of ice in the freezer started to cool from its regular -10 downwards and I thought our problems were solved… It got as far as -14 but since then it has hovered about -11/-10. The ice cream is still not solid 🙁
    The dial is on 5 out of 7 in the fridge and it sits between 3 and 5 degrees. The fan spins and I haven’t heard it pulsing all day.

    Help!!

    in reply to: Liebherr CUN 3031 not cooling #396921
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    By this site do you mean UKwhitegoods?
    If so, then no I haven’t.

    Chris

    in reply to: Liebherr CUN 3031 not cooling #396919
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Hi ELDAR59,

    Just off the phone to Liebherr and they say they will not sell the PCB to me. They will only sell to electrical companies/engineers.
    Any suggestions of how to get it?

    thanks,
    Chris

    in reply to: Liebherr CUN 3031 not cooling #396917
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Hi ELDAR59,

    There is no rush, I’ll be leaving early in the morning for a week, so no more freezer dreams for a while.
    Thanks again for your help, night night.

    Chris

    in reply to: Liebherr CUN 3031 not cooling #396915
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Thanks ELDAR59,

    A part number would be appreciated when you can. Is it easy to change? Any idea on the cost?
    The feezer has been steady at -15 +/- 1 degree all day.

    Chris

    in reply to: Liebherr CUN 3031 not cooling #396913
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Hi ELDAR59,
    I’ve measured the core temperature of the fridge using a glass of water over the last 24 hours. It’s varied between 3.2 and 5.4 so pretty steady. (There is no fan in the fridge)
    I put a small plastic cup of water in the freezer and put a probe in it. The coldest the ice has got is -13 and this morning when I got up it was -8.2. It has slowly dropped back down to -9.5.
    I am waiting for a magnet to come from ebay to test the fan with the door open. I’m not sure how often the fan should be running but I can hear it. Sometimes it sounds steady and other times it sounds as if it is ‘pulsing’ ie 5 seconds on, momentarily stops and 5 seconds on etc.
    Help!! 🙂

    Thanks,
    Chris

    in reply to: Liebherr CUN 3031 not cooling #396912
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Ok, understood.
    Thanks,
    Chris

    in reply to: Liebherr CUN 3031 not cooling #396910
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    I can hear the fan running and it stops when the freezer door is opened. Is it operated by a magnet on the door?
    I’ll get a more accurate thermometer and monitor the temperatures of both fridge and freezer the next few days.
    How much should the temperatures vary? Is between 4 and 8 degrees normal variations for a fridge?

    Thanks again,
    Chris

    in reply to: Liebherr CUN 3031 not cooling #396908
    JamboChris
    Participant

    Re: Liebherr CUN 3031 not cooling

    Hi,
    thanks for the reply.
    The fridge seems to be ok, it does vary between 4 and 8 degrees though. Is that normal?
    The fan seems to be running normally as well.
    Any more ideas? Your input is appreciated.

    Chris

    in reply to: Electric oven recommendations #280778
    JamboChris
    Participant

    Re: Electric oven recommendations

    I ordered the Zanussi ZKC5540 the other day.

    Never used a ceramic hob before…..

    Chris

    in reply to: Electric oven recommendations #280776
    JamboChris
    Participant

    Re: Electric oven recommendations

    Thanks

Viewing 15 posts - 1 through 15 (of 21 total)