[Jetbloke]

So I ran the full Quick Wash cycle…….well!

it drained and then filled as normal then nothing. Nothing nothing nothing. Not a sound, no motor no whirring and as far as I can tell no heating. As before after about 5 / 10 mins it added more water. Then again another 5 / 10 more water and then a third time around the half hour mark and the tray started flooding underneath. I could not for the life of me see where from. No draining though! By this point I guessed the water must be above the door level given there is no water movement inside and that the flooding is the overflow rather than a leak??

The cycle should take 30 mins and after 40 mins I cracked open the door and pressed the reset button to drain. I’ve bailed out the base again and now back to square one.

Think its going to have be an engineer but thank you very much if anything makes sense and you have a suggestion.

[Jetbloke]

Thanks for the reply Dave. I’ve just checked it again. It’s not warmed up and seems to have flooded in base again. Just seems to fill periodically with water and nothing else? Haven’t left it to finish the cycle as don’t want kitchen to flood!

[Author]

Posts