[JGH99]

Re: Thermistor location on Beko CDA565FW

Just wanted to give an update on this.

Finally sorted

I gave up trying to find the location of the fridge thermistor. Instead, I just cut the connector off of the existing thermistor cable. This is the one that goes to KN3 on the control board. Then I fitted a new thermistor into the hole I had already made(see photos above) which is roughly in the middle of the fridge cooling plate. Drilled a hole in bottom right hand corner of the box and ran the cable back to the control board through the foam insulation. Soldered on the connector from old thermistor (not polarity sensitive). Used some heat shrink to cover the joint.

All fitted back together and working perfectly.

Cheers, JGH99.

[JGH99]

Re: Thermistor location on Beko CDA565FW

Thanks Dave

[JGH99]

Re: Thermistor location on Beko CDA565FW

Thanks Dave, Whitegoods have supplied the parts and I have already replaced the one tied to the evaporator. For the other I’m happy to dig out the foam. Not that difficult as I have already done so in the location indicated by others. Just like to find out where it is before I end up with all the foam off.

Cheers, JGH99.

[Author]

Posts