Forum Replies Created
-
Posts
-
Re: Beko DW603
Traced to nts broken wire at hinge where loom bends (bottom door) resoldered insulate and free loom which had attached itself to sticky insulation pad now works fine and loom has a little more movement when door open/closed Cheers thanks for all the info, have a happy wife now.
Re: heater element 1888130100 poss req
Sorted thanks to jimlux found broken wire leading eventually to nts, the loom itself was stuck into the sticky insulation which I don’t think was right so freed it off so it can move a little more when door open/closed. Heat back on and a happy wife. Thanks for all the support
Re: heater element 1888130100 poss req
thanks mate will check that to as sounds more feasible than the other components.
Re: Beko DW603
THS and TF are they incorporated in the flow heater? As both could defo be suspects here
Re: heater element 1888130100 poss req
ok cheers for that I will check this as went to mates house with same model and did the tests on his machine and got same results so I think heater and nts ok
Re: Beko DW603
went to a mates house with same model tested heater and nts both the same readings as mine, if thermistat in heater open will I still get 30ohms from element? And if so how to check thermostat in heater
Re: Beko DW603
sorry still confused I thought the nts monitered the temp and you say new element do you mean heater or nts?
Re: heater element 1888130100 poss req
how do you mean ? I removed the nts from the bottom of the drain sump I suppose you would call it, like a small pen top looking item 2 wires out of it, twist fit
Re: Problem removing Miele dishwasher
anti clockwise yes and yes to WD40 and leave over night to soak in. Could also try a hairdryer to heat the nut then pour cold water over it, expansion contraction type thing, might just loosen it
Re: heater element 1888130100 poss req
beko DW603 I measured the terminals on the heater 30ohms. I also measured the terminals on the NTS, when in room temp 900 when run under hot water dropped down to250ish. Machine runs through wash cycle and completes just leaves everything cold and wet no fault codes showing.
Re: heater element 1888130100 poss req
so any ideas what could be causing no heating? can the nts be tested? I removed it and got 90ohms (cold) ran it under a hot tap went down to about 25-30ohms is that ok aswell?
