Forum Replies Created
-
Posts
-
Re: Siemens SE34A260SK/47 wont heat water, stuck on 1 min
I finally got new relay (my local electronic shop had to order it and it took 2 weeks..) and desoldered the old one.
The burnt area looks kinda bad:
https://www.dropbox.com/s/z2hyhj0xg0hvr … 145420.jpg
And the new relay got 5 legs and the old one only 4. Can it still be used?
https://www.dropbox.com/s/vu2hacf5a6su3 … 150926.jpgRe: Siemens SE34A260SK/47 wont heat water, stuck on 1 min
Ok, I checked what i think was that PCB. And there you can see some burn damage.
Photos:
https://www.dropbox.com/s/mqupvt4xyrqa0 … .47.56.jpg
https://www.dropbox.com/s/ihjk1f1zcpj86 … .48.06.jpgAnd the mouse had chewed 2 wires insulation. One i fixed with tape and other i soldered 5cm of new wire.
What do you think had caused that burn on card?
EDIT: Is it just that relay that have failed? Is it possible to get it working by just soldering new relay there?
Re: Siemens SE34A260SK/47 wont heat water, stuck on 1 min
Martin wrote:Remove the red wire and the wire/green wire from the heater terminals to get resistance readings.
23-24ohm. So its should be working?
Martin wrote:Did I spot mouse droppings in the plastic base?
Yes, there was mouse nest behind the dishwasher and it was cleaned + the mouse trapped couple of months ago.
What is the next thing to test?Re: Siemens SE34A260SK/47 wont heat water, stuck on 1 min
Hi and thanks for your reply!
I started to take is apart and it was quite hard. This is my first time repairing dishwasher :rolls:
It looks now like this:
https://www.dropbox.com/s/fsnyf3d9pj3s4 … 151802.jpg
https://www.dropbox.com/s/s99sughiyvr9e … .09.52.jpg
https://www.dropbox.com/s/orce95r69e7vb … .09.58.jpgCan i test it there or do i need to take it apart more? How do i test it? Resistance with multimeter? Between which two points?
Thanks.
