K8marieuk

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Zanussi FJS1425w water not heating & e41 #346702
    K8marieuk
    Participant

    Re: Zanussi FJS1425w water not heating & e41

    Yes we have a multimeter & my boyfriend knows how to use it, so will post back when the 2 cycles have been done. Am I right in assuming that they can be any full wash cycle?
    Thanks for your post Specialist01269.

    in reply to: Zanussi FJS1425w water not heating & e41 #346700
    K8marieuk
    Participant

    Re: Zanussi FJS1425w water not heating & e41

    Specialist01269 wrote:Hi: Hello 75, would have pulled you up on what you wrote whether you were a man or woman. We know there are Cowboys in this trade as there are in any other. Please do not Tar us all with the same brush, the engineers that provide advice on this forum freely give up their time to do so.

    As I explained above I didn’t tar anyone, simply stated I didn’t want to get ripped off. If anyone found that offensive then I apologise, not everyone out there is trustworthy. 😯

    in reply to: Zanussi FJS1425w water not heating & e41 #346698
    K8marieuk
    Participant

    Well that put me in my place as a woman didn’t it! :-0

    Obviously touched a nerve somewhere but I didn’t mean to offend anyone. There are people out there that aren’t genuine and will try to rip people off as I’ve experienced this, however I didn’t insinuate that was anyone on this board, hence why I’m posting on here as I assume you are professionals!! 

    Anyhow, thanks for your input, but I didn’t open or leave the door at any point during the test so not sure why I got that error but will try as you said again after 2 washes. 

    helo_75 wrote:why do people always end up by calling the people your asking for help rip off merchants?

    do you  not get paid for the job you do? do you overcharge? would it be fair for me to say that youre paid far too much for what you do without knowing your skillset and qualifications, or indeed moneys paid to gain said qualifications

    please choose your words carefully

    as for your fault

    u blew that by leaving the door open when u went into diagnostics.. e41 will show cos it tried to lock the door when it was testing components

    the ee0 is apparant because ur in diagnostic mode
    switching the machine on then off again will cure that

    as for the fault.. do 2 more washes abd then go into diagnostics again, only next time do it properly

Viewing 3 posts - 1 through 3 (of 3 total)