Forum Replies Created
-
Posts
-
Re: NEFF Dishwasher programme ending too early
Thanks for your advice. Why would the drain pump semi jam with heat only? Is this something we could clear?
Re: NEFF Dishwasher programme ending too early
I’m using the FINISH tablets. However I’ve also tried a wash with dishwasher loose powder and the outcome is the same.
Yes the water is hot when the dishwasher beeper goes off. It seems to be at the end of a hot wash cycle and just doesn’t drain off….from the amount of soapy water left behind, it looks like it should go through another rinse stage before finishing, but stops too early.
Re: NEFF Dishwasher programme ending too early
After what seems to be a year of working ok (on and off) our NEFF diswasher ( S5453X1GB/50) seems to be ending too early on wash cycles again leaving foamy water at the bottom (yet the beeper is sounding to alert end of cycle).
I’ve tried doing wash cycles with no detergent as recommended last time in the forum but this time it doesn’t seem to get any better. Strangely on a plain rinse cycle the water drains out fine. I can do a few rinse cycles in a row and water will all drain out. As soon as I do a WASH cycle with no detergent, it leaves water in the bottom of the dishwasher and I have to reset it to drain it all out.
I actually had a NEFF representatitve come over to look at the machine in January but he said he couldn’t find anything wrong with it. However he didn’t put it thru a wash cycle when he was here, he just looked at all the parts.
What part of the wash cycle could be causing this?
Re: NEFF Dishwasher programme ending too early
No don’t think I interrupted drying phase – definitely waited for dishwasher to finish the programme before opening the door. The dishwasher beeps loudly to alert end of programme (and continues to do so until someone turns it off). So not sure if beep is coming on too early?
Have done a few cycles without detergent as Dave suggested and seems to be improving and the machine has drained at end of cycle. Will do a couple more cycles, and hopefully problem has been fixed.
THANKS
