Keith T

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 23, 2020 at 11:24 am in reply to: Neff B16P42N0GB/04 bulb problem #465904
    Keith T
    Participant

    Thanks Dave – I’ll check this out. Footprint is 5.0 x 2.5mm. Much appreciated

    January 22, 2020 at 9:50 am in reply to: Neff B16P42N0GB/04 bulb problem #465902
    Keith T
    Participant

    I agree and will try to fix it before having to buy a new board. I The resistors are marked with a a single “0”. I tried Farnell and RS but could not be certain about finding a replacement (and without buying a 5,000 unit reel). Do you have nay suggestions Dave?

    January 19, 2020 at 12:26 pm in reply to: Neff B16P42N0GB/04 bulb problem #465900
    Keith T
    Participant

    Both zero ohm resistors have blown. I’ll resort to getting a new PCB

    January 16, 2020 at 4:25 pm in reply to: Neff B16P42N0GB/04 bulb problem #465899
    Keith T
    Participant

    Thanks again Dave – I’ll check this out

    January 14, 2020 at 8:38 pm in reply to: Neff B16P42N0GB/04 bulb problem #465897
    Keith T
    Participant

    Cheers Dave – I’ll measure up and check online as well. There may be another one gone as well (possible burn mark on one end) so may need 2 in the end.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)