[kgaf]

Re: Zanussi Jetsystem 1600 (XC6) WJD1667W diagnostic mode

Hi again,
I think I got the machine into diagnostic mode (with it cycling through all the LED’s) but don’t know how to interpret or make it check specific components.

Anyone able to help with doing that?

Interesting that all the LED’s are off including the display giving the impression its pretty much dead but will go into diagnostic mode.

[kgaf]

Installed a new pump the next day and all working fine again.
The wife says that it had a new pump under warranty as well. Machine about 5 years old now so it seems a bit much two replacement pumps in 5 yrs.

K

[kgaf]

Jim,
What about when its out of the coil – should it be free then ?
I’ll test it later when I’m home.

Thanks

[kgaf]

Re: Zanussi – WJD1667W E20 codes

OK have removed pump easy really – Turn off power and just lie machine on side. The pump is at bottom of machine just behind the fluff filter towards the front (just follow the drain hose towards the front of machine if you can’t see it).
From underneath remove the three screws that secure it in place. Unclip the two wires as well. A small amount of water will drop out of it.

The impeller piece (plastic housing) can be removed from the main body by unclipping the tabs on either side and sliding it out of the magnet.

Question I now have is: should the impellor be stiff to turn or should it be really free? Have tried some WD40 doesn’t seem to make it any better as yet.

Thanks

[kgaf]

Re: Zanussi W/D WJD1667W not drying

I think I’ll have to call myself a local engineer then !!

Whats so difficult about that then –

For anyone else out there who needs the info – obviously at your own risk !
Power off and disconnect first.

Remove lid (two screws at rear).
2 x 8mm hex head screws either side at floor level.
3 screws at rear floor level (two on right hand side)
Remove the cold water inlet for ease.
Carefully remove casing.

1 screw securing fan assembly from rear (just left of center)
4 screws on top in middle of machine securing cross member type structure (only remove two either side, leaving the front 4 in place on this member).
The plastic ducting bewteen the top of the condenser and the water pipes on the right hand side can be unclipped at each end and removed.
Slackening off or removing the screw holding the fan assembly in place towards the front allows the condenser to be removed from the underside of the fan. Once this is done, the condenser to drum rubber “boot” can be removed and the condenser released from its lower securing by sliding a narrow blade down the side of the plastic housing rather than releasing the wedge from underneath.
Clean the condenser out with a hoover, piece of wire and wash/soak if needed.
Hey presto – dry clothes again and no unnecessary call outs.

[kgaf]

Re: Zanussi W/D WJD1667W not drying

Hi,
Thanks, any further instructions pls? While its bad enough not having the dryer, I don’t want to end up not having the washer as well – as having 7 month old twins generates quite a lot of washing!

[kgaf]

Re: Bosch Hob ignition

Thanks for reply – So whats likely to be wrong with it ? Have cleaned it but as its same for all four burners didn’t think that was going to make much difference.

Kev

[Author]

Posts