[kiers]

Re: tbdw41 Problem

Thanks again Penguin, I accept the mission………

[kiers]

Re: tbdw41 Problem

OK, I am getting my head round buying the new part. How hard is the fitting going to be? I know its all relative, but I do know which end to hold a screwdriver and I’m an engineer of sorts by trade.

[kiers]

Re: tbdw41 Problem

I have sat and watched the IWMS throughout the wash, (I don’t get out much) and can now see that at several very specific points the leak happens. The rectangular hole appears to be to vent air as water levels go up and down in the IWMS’s internal channels. At certain points the water level rises high enough to send water out of this vent. There is loads of brown muck in the channels below this vent chamber, are they the cause? I will buy the new part if I need to but I just sense there is something simple going wrong….Thanks again for your attention.

[kiers]

Re: tbdw41 Problem

Many thanks for the prompt help Penguin, I will get on the case.

😀

[Author]

Posts