[kmc]

Re: Smartdrive 085 won’t fill

Thanks for the email. Did as advised but the spares guy was pretty adamant the board was ok and even went through a quick wash, rinse & spin cycle whilst I was there – all seemed fine.

He suggested to try resetting the load size setting to 5kg ie. Hot + Power, then Hot buttons to set it to 5kg.

Turned machine off and on again, and presto, it started to wash.

All looked rosy until the spin cycle, at which stage it stopped. It now seems to be trying to spin, some water being drained then stop. Repeats this a few times then stops with error (R->L) 10110000.

This also shows in diagnostic mode, with Hold + Slow on.

Time for a pro ❓ Wife is getting a bit peeved and I’m running out of jocks! 🙁

Cheers

[kmc]

Re: Smartdrive 085 won’t fill

Penguin45,

Went to get a recon motor controller board and the guy thought that it more likely be one of the valves. Did a quick test on the controller board there and then and it seemed to work fine, so I took a couple of valves instead.

Sure enough though the problem is still there but there did seem to be a problem with the valves not working. In diagnostic mode the water flow looks fine now, and I can get both cold and hot water coming through at the right pressure, which wasn’t happening before. However the error codes are the same, 10010000 for SH (0011).

There is a couple of different outputs now though at other stages, for F (1000) I get 00111000 & 11011000 alternating. And for FM (1100) I get 11000000.

I just wanted to check back with you that it was still likely to be the controller board, before I make the purchase.

Also, is there anyway in diagnostics to empty water from the machine, as there is a bit of water in there now after testing the valves.

Cheers. 😕

[kmc]

Re: Smartdrive 085 won’t fill

Thanks for the prompt reply. I’ll double-check the connectors and then look at replacing the board.

I’ll let you know how I go.

[Author]

Posts