Forum Replies Created
-
Posts
-
Re: indesit part number
sent off details as advised, but the wrong part has attived. They have sent the wider of the 2 hoses, not the narrow one.This (wrong) hose also has two “mouths” at one end. Either I got the wrong number here or they have sent the wrong part by error…..first i have to establish that i do, or don’t have the right part number.
Re: indesit part number
there are several numbers, on the back and on top of the drum housing,…which 1 is it ?
Re: indesit part number
did as you suggested, but got this email back….
“If this is the hose from the bottom of the drum to the pump/filter, there
are two types, could you advise the serial number please.”How do i sort this, is the serial No printed on the hose (haven’t taken it off yet).
Re: indesit part number
Went out today to the flat and checked things. The hose is located at the bottom of the machine.There are 2.The one that is leaking is the narrower of the 2 concertina type hoses.It attaches to the drum with a large circlip, it is wide mouthed at this end. At the lower end it is the same width as in the middle and attached by a smaller circlip to what looks like a little pump. The hose is rubber, soft and very pliable. And black.
Re: bosch v454…water pouring out
checked this hose and it was clean and clear.Blew through from both ends and no blockage. What now?
Re: bosch v454…water pouring out
just looked, 3 hoses all the same, doble cold i think BUT there is a 4th hose, much thinner, which goes to the top of a kind of plastic “bottle”, which is then attached to the waste water outpipe. Is this the fella?
Re: bosch v454…water pouring out
there are 3 hoses to/from the back of the box, hot/cold and maybe the 3rd one is the vent hose?
Re: indesit part number
will go get a look at the part bexactly tomorrow, in daylight! Thanks and i will get back on the 1.
Re: bosch v454…water pouring out
Thanks for the reply.Have taken box off to look, but couldnt see a fault or blockage. The water goes in fast as usual, but after a few secs it pours out like a wee waterfall down the machine front. I thought there might be a seal at the front missing. Checked the main pipe into the drum but it seems ok too.
