Forum Replies Created
-
Posts
-
Re: Hotpoint Aqualtis no water!
i had an engineer out tuesday.. he said its either the pressure switch or main board. i’ve tried a new pressure switch today and still the same so guess i just have to hand my money over to Hotpoint and let them fix it..thanks for the help.
Re: Hotpoint Aqualtis no water!
Yes Martin checked a few times just to make sure.and the flows good.
It’s still under the 5 year parts guarantee would hotpoint just post me part or will I have to pay tgeb ridiculous call out fee for an engineer?
Re: Hotpoint Aqualtis no water!
could it be anything to do with the connection where the cold water feed connects? i have had it off and there seems to be two electronic switches on it?
Re: Hotpoint Aqualtis no water!
tried it again this morning and sill nothing. i’ve put the drain pipe into a bucket and added more water to the drum when the cycle starts its pumping water out so im guessing no blockages? its just not feeding the cold water in there is no water going throught the softner draw at all its bone dry. the machine seems a git to work on you can only take the top off and a port hole at the back everything is under the drum but don’t want to tilt the machine to go underneathe it and damage it more.
any ideas?
Re: Hotpoint Aqualtis no water!
the part i checked was the cap down the bottom in front of the impeller cleared out the blockage there nd checked there was nothing else. should i take the pump out? iv’e had all the pipe and u-bend off under the sink to make sure there was no blockages where the drain from the washer conected also. i did notice earlier after the door lock got stuck on that water was coming out from below the door and it now seems to be letting air in? also the lock keeps sticking on and i have to maualy open the door.
Re: Hotpoint Aqualtis no water!
just tipped the 2L of water in. the pump is now churning water rather than humming but still no other water entering the drum?
Re: Hotpoint Aqualtis no water!
hi, i read online that you can reset the pressure switch by blowing down the pipe? i didnt blow too hard as straight away i could tell it wasnt blocked..hope ive not caused more damage? i didnt tilt it back far at all just slightly to get a container under the filter at the bottom.
i will try the water in the drum and see how that goes.thanks for your help so far guys.
