martinm

Forum Replies Created

Viewing 5 posts - 166 through 170 (of 170 total)
  • Author
    Posts
  • in reply to: New Dishwasher from Howdens – confused by salt #272010
    martinm
    Participant

    Re: New Dishwasher from Howdens – confused by salt

    I would recomend Finish, should see an improvement. The water level in the salt chamber will never go down so dont worry about that, just replace the salt when indicated.

    in reply to: diplomat dishwasher fault codes #271821
    martinm
    Participant

    Re: diplomat dishwasher fault codes

    E1 The anti-flooding system has tripped (if applicable)
    E2 The level safety device has tripped
    E3 The machine is unable to heat the water
    E4 Temperature sensor disconnected
    E5 The machine does not fill with water
    E6/E7 The machine does not drain the water
    E7 The machine is looking for a flow meter
    E8 The alternating valve does not operate (only models with alternate washing cycle)
    E9 See Alarm E2

    in reply to: Diplomat ADP8224 #271818
    martinm
    Participant

    Re: Diplomat ADP8224

    Quickfix:
    Remove sump filter and gauze, towards rear right in sump there is a hole about the size of a 2p. There may or may not be a rubber flap covering it. Check to see if flap is bunged up with grease and stuck closed, but also you need to poke something up throgh the hole to clear any grease in the tube. I normally use a piece or rubber hose pushed in about 10 inches give a a good wiggle whilst also blowing up it and as you draw it back out you should see all the crud comeing back into sump. That sould be it unless it is realy badly blocked in which case you will probably need to remove and replace the air break on the right hand side because it will be bunged up, so try first method and see how you get on normally cures it for me.

    in reply to: ADP8332 F2 mystery #271508
    martinm
    Participant

    Re: ADP8332 F2 mystery

    i would have to agree its probably syphoning, I think these wirlpools like syphoning more than any other

    in reply to: Beko #264649
    martinm
    Participant

    Re: Beko

    I have been asked about doing some beko work as well and was wonering the same as you?

Viewing 5 posts - 166 through 170 (of 170 total)