Forum Replies Created
-
Posts
-
Re: hoover hsv170 thermostat
was hoping to find out what temp it should be because its possible i have one but thanks anyway
Re: Hotpoint EW74X tripping
regardless of what was on at the time it tripped it will probably be one of the elements, a mega test is needed to find out the problem.
Re: Whirlpool ADG7550 4 flashes
check gauze sump filter for greasy film on it or check for proper air gap on outlet hose connection to trap/sink. Also i have seen a low insulation reading on wash pump cause this before
Re: Belling Format 647
Check that fan is running ok in back of oven keep door closed and peep in through glass
Re: whirlpool dishwasher F2 fault code
f2 is water present in the base tray, remove bottom cover and have a peep in to base to see if its leaking from anywhere, make sure you disconnect it from the electricity first!
Re: Hygena APP 2210 Cooker hood is blowing fuses.
the pcb/swithes is normally the culprit on these or sometimes the lampholders. Check to see if there are any of these parts have blown(looking for black carbon blow marks). ***Make sure that it is unpugged/disconnected from electricity first!***
Re: diplomat dishwasher adp8101 water staying cold
there is a thermostat reset button on these which is probably the cause. If you remove the right hand side panel you will see the red button on thermostat at bottom of dishwasher, I must emphasise make 100 percent sure that the dishwasher is unplugged/disconnected first.
Re: whirlpool dwf417
that would suggest that its one flash then(f1) flash pause flash pause e.t.c.
f1 is the fault code for a faulty thermistor
