martinm

Forum Replies Created

Viewing 15 posts - 121 through 135 (of 170 total)
  • Author
    Posts
  • in reply to: Creda Concept Solarglo. Suddenly Slow oven #292578
    martinm
    Participant

    Re: Creda Concept Solarglo. Suddenly Slow oven

    if your sure that it is heating up then heat must be escaping possibly through door not closing fully or seal, but the usual is the fan element fails and there is no heat just fan turning.
    Sounds like your inner grill element is gone in your top oven its probably getting hot from transfered heat from the outer element which is used on top oven only

    in reply to: Servis D/W #292637
    martinm
    Participant

    Re: Servis D/W

    Have a read of this
    http://www.ukwhitegoods.co.uk/modules.p … ge&pid=240

    in reply to: DIPLOMAT D/WASHER ADP8322 DEAD (314904) #292522
    martinm
    Participant

    Re: DIPLOMAT D/WASHER ADP8322 DEAD (314904)

    a poor insulation value will normally cause the pcb to lock out

    in reply to: Zanussi WD1680 #292291
    martinm
    Participant

    Re: Zanussi WD1680

    if it were your carbon brushes then your drum would not be turning at all, is this the case?

    in reply to: Diplomat ADP 8352 flooding – long story..! #292172
    martinm
    Participant

    Re: Diplomat ADP 8352 flooding – long story..!

    if its a slimline you got then stick to powder not tablets as most of the tablets are designed for 600 wide dishwashers and tend to over foam in the slimlines causing water in to the base

    in reply to: ADP8502AL dishwasher #292187
    martinm
    Participant

    Re: ADP8502AL dishwasher

    have you checked the insulation reading?

    in reply to: Diplomat D/W ADP8132 Fills And Pumps #291643
    martinm
    Participant

    Re: Diplomat D/W ADP8132 Fills And Pumps

    normally blockage in bottom of air break or rubber flap in sump stuck or the biggest black hose from sump to air break blocked with gunge, try cleaning out this hose from inside the sump with a plastic tie, the hose elbows to the right over to the air break. If its not that then looks like pcb assuming that the isulation value is good as a low insulation value on these will cause wierd displays on pcb

    in reply to: built in Diplomat washer dryer HPA8703 #289919
    martinm
    Participant

    Re: built in Diplomat washer dryer HPA8703

    have you checked the little ruber hose on bottom of condenser for blockage ?

    in reply to: hoover/candy int f/f fridge thermistor #270040
    martinm
    Participant

    Re: hoover/candy int f/f fridge thermistor

    ok Chris put me down for a copy
    cheers

    in reply to: Creada 48341 Cooker #286529
    martinm
    Participant

    Re: Creada 48341 Cooker

    should turn down when you turn down the regulator, cant see it being the limiter. Maybe regulator or plate incorrect wiring?

    in reply to: aeg washer model 88730 #286153
    martinm
    Participant

    Re: aeg washer model 88730

    i had ec3 the other day and there was no weight sensor on it, it turned out to be loose motor plug, so probably going to be a motor asociated fault

    in reply to: Diplomat ADP8352 on/off light only, otherwise dead. #282266
    martinm
    Participant

    Re: Diplomat ADP8352 on/off light only, otherwise dead.

    a low insulation reading normally causes the pcb to lock out on these

    in reply to: Diplomat ADP8322 #281945
    martinm
    Participant

    Re: Diplomat ADP8322

    if it sborts it should be giving you a flashing start light. how many flashes is it giving?

    in reply to: Diplomat ADP8322 – Tablet problems #281850
    martinm
    Participant

    Re: Diplomat ADP8322 – Tablet problems

    it sounds like your wash motor is gone as is common on these, get a quote from someone near you but youll find it well over £100 if i am right

    in reply to: diplomat HJA8630 dishwasher #281107
    martinm
    Participant

    Re: diplomat HJA8630 dishwasher

    last one of these i had doing that it was the flowmeter on left hand side, supposed to bring up an error code but it was not

Viewing 15 posts - 121 through 135 (of 170 total)