Forum Replies Created
-
Posts
-
Re: Ignis ADL348….why me?
F4. 4 Flashes. Draining failure. Drain pump, control board OWI or water indicator defect.
i would check for a kink in the outlet hose behind the dishwasher first
Re: Zanussie ZWX1605W stops during wash and rinses
put it in to diagnostics see what code it gives you
Re: ed4 – new zannussi/electrolux W/D
Yes i’d agree with that, check your insulation reading anything lower than 30meg change it because otherwise you will get silly error codes
Re: Whirlpool dishwasher ADP4501/5
FA. 11 Flashes. OWI failure. Dirty OWI lens. OWI defect or control board defect. Check cabling.
optical water indicator faulty problem, i think its situated on left hand side on air break
Re: Whirlpool G2PDWI Dishwasher advice please
F4. 4 Flashes. Draining failure. Drain pump, control board OWI or water indicator defect
make sure that it is emptying properly first, check sump filter and end of the waste hose where it connects to for blockages
also remove mesh grid inside sump inside dishwasher and on the right hand side bottom there is a round black thing, this is your water indicator give it a good cleaning and try that
good luck
Re: AEG Lavamat 50420
if water is emptying quick enough and pressure bottle clear then youd have suspect motor overheating ant cutting out on its own toc
Re: Creda C363E Top Oven/Grill Door Will Not Close
sounds like the hinge has disengaged, just a case of getting it back in to sit properly unless its broken. ther is usually a way of locking the spring in the hinge to help but there are various types of hinges, have a read of your manual perhaps it will explain in there
Re: Ikea Whirlpool DWF 416 Problem 8 Flashes
F8. 8 Flashes. Water level failure. Sieve strongly dirty or big amount of foam inside to less water.
make sure the sieve filter is clean, hold it up to light to look through it as it has normally got a thin greasy film on it which you won,t see at first glance.
try that first, otherwise the pressure switch in sump usually go on theseRe: diplomat dishwasher ADP8332
just add the salt to the water and then replace cap, the rinse aid chamber is next to where you put your powder/tablet usualy a cap you unscrew
