[mcgroa]

Re: tkd 795/3 tecnik -new pump fit? advice vs comet “re

So anyway. Dearth of pump replacement explains on here. It’s easy.
Unplug
Take sides off (screws are on front inside door seals).
Take door outer off
Undo two screws on back corners of white under tray.
Undo two tiny screws about 2/3 way down each side on bars that hold main case to bottom.
Inside:
Undo screws inside on spray arm mount under filter and remove from
Undo two screws with White retaining clips that hold under pump assy to metal case.
Door: completely remove door by removing all screws round the edge.
Now you can rock the main casing lose from base (main resistance is from then big pump filter assy at bottom with big round seal).
You will then find you need to open the now doorless door hinges one by one to prise the main casing from getting stuck on door hinges.
You should then be able to get to pump motor without comletely removing (when you are losening watch out for all pipes and floats on lhs of machine and dont bend too much)
Use your camerphone to track the wiring as you remove from motor and motor capacitor.
Undo jubilee clip on motor out pipe that connect to heating element. Prise black pipe off.
Wiggle pump input from filter housing and it will come free.

Buy pump.
Refit.

[Author]

Posts