Forum Replies Created
-
Posts
-
Re: Kenwood CKB200
Hi All, I have replaced the bottom element & did not find it easy as old element was so distorted it broke up while I was pulling it out & I had to make a hook out of an old wire coathanger to pull all the bits out, Even this was not easy as the element slides into a narrow drawer under oven floor which makes it difficult to see what you are doing. Anyway its done now!, Regards Mike
Re: Kenwood CKB200
Hi, I have replaced the oven safety stat, It was located on rear wall of oven to the left hand side, To get to it I removed the top & rear covers & this exposes about anything one would need to replace in the oven,
Whilst I was in I tested the lower element as I had doubts if it was working & found it was open circiut, So have ordered a replacement. Only time will tell if changing the safety stat has cured my initial problem, but if it happens again I will try changing the oven stat. Regards Mike.Re: Kenwood CKB200
I have ordered a safety thermostat & I am going to change this & check the operation of the cooling fan also clean the fan ducting. Has anyone any idea where the safety stat is mounted on this oven, Regards Mike.
Re: Kenwood CKB200
Thank,s for reply, I will monitor it for the time being & see if it goes off completely so I can trace fault. At the moment it has only happened twice in 3 months & by the time I would be able to get into the oven to test it it would have reset, The temperature thermostat seems to be working as the temperature indicator light is going on & off as normal when oven is maintaining set temperature. Regards Mike.
