Forum Replies Created
-
Posts
-
Re: diplomat ADP8322
It is a whirlpool the problem is the pressure switch if you lift the filter in the base you can see a mesh on the right hand side more than likely its all blocked does’nt release when drains so f4 comes up. Flow meter is 7 X flashes.
Re: MFI Turmoil
Yes its true just had phone call all stock to be returned to nearest MFI store by Dec 5th Anyone want a experience engineer with 4yr left on gas certificate? Southwest area 🙁
Re: diplomat range
Hi wayne, it will be a bit involved.Take off control knobs,then control panel.slide out the centre hob dividing piece.Go to the sides and take out the plastic plugs, 4 in total.The 2 hob tops should now be released.If a new one,these may also be screwed down.gently lift the hob tops and all is revealed.Take the screws out the phial plate right rear.Undo the screws for the relevant back plate so the rear is open for you to see access to the hole where the phial enters the oven cavity.Pull off phial from inside the oven so its free.Pull through ,unscrew the stat,fit all wires to new one and reverse all actions.Hey presto,another hour gone out of your life.Hope all goes well, all the best.
Re: Diplomat ADP8332
Hi, yes agree with post, flood alert/Most likely on this model that the small hose, recirc motor to sump is leaking.This corresponds with faults and codes.As the hose is not a part, new recirc motor has to be bought.All the best
Re: Diplomat ADP8252 dishwasher.
H Steve, yes the pcb’s are £115.72 plus vat and postage.This sounds like one of those jobs you get at 3pm on friday and wish you had never started.When the pcb’s lock out there are so many reasons and I am still finding new ones after 30 years.I would go for a pcb but any break in the wiring will cause the symptom.A stuck flood switch can also do it.As it is on P0, it sounds like it had aborted the programme and defaulted to drain.
Sorry cannot be more specific but I think it will be trial and error.All the best.Re: Diplomat ADP8252 dishwasher.
Hi, pull the motor plug off and see if that does the trick.If there is water in the base it causes the motor to lock out the pcb.It may be the o rings on the air break leaking if there is water in the base.Does the pcb bleep twice when you press the P button.You have tried all the usual tricks, motor plug, dispenser solenoid/wax jack.If this still will not programme,cut the covering off the loom where it bends under the door, I have had wires break and it gives this fault, usually the white ones.other than that pcb.Hope this helps.All the best.mendy
