Forum Replies Created
-
Posts
-
Re: Candy CWB714 not spinning
I’ve watched the water outside going into the drain,it comes out at a good fast rate and the machine empties quickly.
MikeRe: Candy CWB714 not spinning
Hello again Martin,
Latest position is that I replaced the pressure switch and blew down the hose to clear any possible blockage. Could hear the blowing in the drum so that seems to be fine. Have tried the machine on a full wash and it stops with around 33 minutes to go just after it has pumped the water out. On a quick wash it stops at a minute to go again after pumping the water out. On just a spin cycle of 9 minutes it stops at 3 minutes presumably just as it is about to go into full spin mode. All this to me suggests it thinks there is water still in the machine when there isn’t. It just won’t spin at all.
Am starting to think about replacing the PCB which is a bit drastic but is maybe all that is left to do.
Regards,
MikeRe: Candy CWB714 not spinning
Latest position is as follows Martin:-
Fitted a new pressure switch and the problem is still there.
On a drain cycle the water is pushed out at a good rate and the machine quickly empties.
I’ve taken all the waste off and was able to feel the drum without finding any obstruction.
Would fitting a pump to the pressure switch hose to get a good blow through be likely to damage anything?
Regards,
MikeRe: Candy CWB714 not spinning
Thank you for your help Martin, gave it a good blow but the problem remains. Going to try a new pressure switch and see how it goes from there.
Kind regards,
Mike
