Forum Replies Created
-
Posts
-
Re: Diplomat 8322 water entry fault 4 flashes HELP!!
OK I have checked the water valve and I`m getting a reading of 3.6k Ohms. So the valve seems ok. I have bought a new one anyway so `i`m not sure if I should fit it anyway? What I have noticed is there was a fair amount of water in the drip tray underneath. Could this be a clue to the problem.?
Re: Diplomat 8322 water entry fault 4 flashes HELP!!
Just to add to my post above. I have removed the water infeed pipe below the sink and tried to see if there is some sort of suction from the pipe while the machine runs, I even tried to blow into the pipe but there is no flow. It is like trying to blow into a blocked pipe. Is this possibly the problem?
Re: Diplomat 8322 water entry fault 4 flashes HELP!!
Just replaced the the microswitch with a new one but I still have the same fault.
When the wash cycle starts you can hear the drain cycle start first and then the next cycle should allow for the water to enter but this doesn’t happen. A 4 flash code follows.Any suggestion?
Re: Diplomat 8322 water entry fault 4 flashes HELP!!
Thanks will give it a go!!! Will report back the results. Once again thanks
Re: Diplomat 8322 water entry fault 4 flashes HELP!!
Thanks Penguin 45. My apoligies for going on with this but could you possible explain a bit further on locating this microswitch. You mention access by removing plug(which one and location). Door decor panel……the shiney bit on the inside?The lower cover plate………below the door area. Many thanks
Re: Diplomat 8322 water entry fault 4 flashes HELP!!
Gave all the filters a good clean including the black filter. I still have the same result. You can hear the dishwasher run but no water enters the system. I have poured water in and it drains fine. One forums suggests a WI sensor on the left panel? How do you remove the left panel? or could it be the pcb? Your help is appreciated.
