[mills]

Re: MW051 Phase 2 Water valves and no spin-error 16

Thanks for your input Penguin45.
I have carried out all your checks, I now have the cleanest wiring loom, cleanest pump and drive motor inside and out, working OOB and lid switch and working RPS and still got error 16 🙁 so I bought a new motor controller and hey presto my wife loves me again!! 😆
As an engineer it still irks me that I could not find the fault in the motor controller however that’s life sometimes.
Thanks again and keep up the good work.
Mills

[Author]

Posts