[mossup]

Re: AEG Lavamat 86741

No I don’t get any error messages. But if I just lightly touch the start/pause button the flashing stops but it is very temperamental.
When you say strip and clean, you mean unscrew the control unit from the back of the fascia and clean carefully?

Sorry for late reply but been away

Thanks for your help

[mossup]

Re: AEG 86741 Update

Hi K,
Changed the valves and all OK.
Thanks for your help,

[mossup]

Re: AEG 86741 Update

Hi K,
Thanks for the link.
Do you believe it is a good chance that it is the valve not passing enough water thro?

Thanks Again.

[mossup]

Re: AEG 86741 Update

Hi,
I have just noticed that the C1 fault only appears when doing a cottons/linen wash and it shows C1 at the start of the rinse part. So I am wondering whether it is the water not coming in quick enough because when I press the start button it then fills up more and then it goes on thro’ cycle to the second rinse where the C1 happens again and pressing start initiates filling again and then it completes the total cycle.
Can anyone please confirm if this is a valve not opening fully problem, as I do know that the white valve does not pass water as fast as the black valve from some previous testing I have done.
Can you also tell me the part to order please (PNC no is 914 002 562 00)
Thanks

[mossup]

Re: AEG 86741 Update

Thanks K,
The pressure switches click OK when blew in
I have blew out the pipes to the pressure switches and OK
Water is flowing in OK
Ref the valves, one does not flow as much as the other but whether that is right, I don’t know.
Electronics woooooow !!!!!!

Is there any way of getting hold of diagrams , wiring and mech of these machines?

Otherwise I guess I’m stumped but thank you very much for all your help,

Regards

[mossup]

Re: AEG 86741 Update

Hi K,
PNC no is 914 002 562 00
Ref the valves I have tested them and they all work but the one that feeds the prewash side of the dispenser does not flow the same as the wash sided one i.e less flow rate (white solenoid is less than black solenoid). Could this be the issue?

Also noticed that some of the times for washes has gone up after doing what I thought was a reset (press prewash and sensitive then turn knob to short spin wait for lights to stop flashing then turn to off). Why would this have affected the wash times? Can I reset this back? How do I do that?
This is over and above the C1 issue.

Your help is greatly appreciated,
Thanks

[Author]

Posts