Forum Replies Created
-
Posts
-
Re: Siemens mains suppressor advice
Thinking of it, the thing is full of water right now and its not doing anything, it does about 3 clicks from the rear at the bottom when selecting a program, flashes “sensor” on the display, then does nothing –
Re: Siemens mains suppressor advice
But even when it was connected to the aquastop, and wired up corrrectly with the water hose disconnected from the aquastop block, it was not letting water through, I think when i got it working today, it only ran on the old stagnant water that was already in the unit, then when it drained that out, it wont fill, it didnt do a rinse cycle or anything. So i think the issue is, it wont take in water, both with aquastop connected and disconnected, but the aquastop was closed anyway. Hope im being clear enough, many thanks electrofix.
Re: Siemens mains suppressor advice
Thanks Martin & Don, I managede to bypass the offending item and the dishwasher started to work. It got halfway through a cycle, drained, then stopped. The aquastop wasnt letting any water in i have found, i have removed the aquastop and im using the normal hose, now i have 3 small wires down by the water inlet that was connected to the aquastop, they are just hanging there and now the dishwasher is saying “SENSOR” on the display when powering it up, it clicks once or twice then doesnt do anything, the sensor text goes away and it seems dead.
Can anybody advise what i need to do with the aquastop wires or anything else?
Many thanks. Nick.
