[november]

Re: HooverHD

New heater fitted and everything is A OK — old heater had a very small leak to earth when megaed at 500v — 58, thanks again and I hope this thread can help others.

[november]

Re: HooverHD

Great advice from all!! I cannot explain the whys or the how’s but tonight I have disconnected the heating element as per helo_75 and the washer has completed two full washes (must have been a good cover our profits memo from Hoover) I will fit a new element as soon as and post the outcome here for other users. A big thank you to all.

[november]

Re: HooverHD

Many thanks mate, the pressure switch works fine and I have cleaned everything as new so I was close to ordering a new mother board but I will try a new heater and post the result. Thanks again.

[november]

Re: HooverHD

Thank you I really appreciate your help, yes it does drain but the pump does not seem to stop it just keeps pumping even though the drum is empty. I will check the pipe work and tubes leading to the pressure switch. Can I bypass the pressure switch to check if it is this that has faulted? Thanks again.

[november]

Re: HooverHD

Thanks for the advice, I have cleaned the fillter, checked the pump and discharge pipe (all seem ok) and it still goes into error can yo tell me how it detects if the washer is empty? thanks again.

[Author]

Posts