[Noz85]

Further update. When i choose a program and press start. The machine at times will immediately spring in to life and complete the program or more often than not, will do nothing whilst the timer ticks down. 5 to 10 minutes pass and the machine springs in to life. It may then complete the program or run for a random amount of time and then stop running whilst the timer continues to run. It may run again … and so on.

Sensor issue? I don’t think it is a door issue as the timer would stop and the program would be paused which isn’t happening. Also when you open the door mid program (running or not) the alert sounds and the program pauses.

I have an engineer booked in tomorrow.

[Noz85]

Thanks. Will try this also but we will have to get someone out to it now as it is so bad we can hardly use it

[Noz85]

Can I bring this thread back to life please?

My Grundig tumble dryer is presenting the same issue. It has gradually got worse. Choose a program and press start and nothing mechanically happens but the display says the program is running. It has also stopped running part way through a program more recently. It used to work after a while or the next morning. But recently I have come to try it in the morning after a good 10 hours idle and it still doesn’t work.

I will remove the lid and try the steam searching test. Could it be a software glitch? Is it possible to perform a reset?

Thanks

[Author]

Posts