Forum Replies Created
-
Posts
-
Re: Bosch WTA4107GB/01 tumble drier not getting hot
Replacement part arrived today (courtesy UKWG), just fitted and all working. Thanks once again!
Re: Bosch WTA4107GB/01 tumble drier not getting hot
OK, tested the element, and it’s open circuit, so need a new one…
Re: Bosch WTA4107GB/01 tumble drier not getting hot
Any ideas folks? Some pointers for diagnosing the problem would be helpful.
Thanks!
Re: Bosch WFF1201 with sticking door
Ok have checked the pump filter and the air-bell, all clear. I will therefore move on to the door lock, but can’t see the best way to access. Can you give me a very brief idea of which way to go – from the top, from the bottom, or does the whole front panel come off? Ta! Neil
Edit – sussed out how to get at the mechanism through the door opening. Tried the technique of a gentle thump around the handle and hey presto the door release, have then had the interlock out, checked and refitted. Initial test showed it to work, we will wait and see over the next few washes. Seems to be definitely the interlock though…
Ta for the help – Neil
Re: Bosch WFF1201 with sticking door
Thanks Penguin45, that gives me somewhere to start! Will report back…
Re: Bosch SGV4313GB/17 not cleaning well…
Penguin45 wrote:Plug out. Remove door outer panel, plastic kick board, then lower cover plate. You will need Torx bits to do this. Corrugated hose in the left hans corner and simply pulls off. Clean thoroughly.
Penguin45.
OK, done that, hose was very gunged up as you predicted so thanks for the advice. However…. Neither top or bottom spray arm now spins, as far as I can tell. On opening the door there is a good 3-4″ of upward spray off the lower spray arm, but no rotation. Arm is clean and spins easily enough by hand (upper one is still stiff so will order a new one of those I think). I think the lower arm was spinning before the de-gunge – so what have I done now?! Next things to check?
Ta!
Re: Bosch SGV4313GB/17 not cleaning well…
Penguin45 wrote:You need to clean out the hose under the tub in the bottom left hand corner – it will be full of goo, causing the machine to underfill.
Power off before going in……….
Penguin45.
Can you give a quick run down of how to get in there…? Ta!
