[osc]

Re: Bosch WVT 1260 – doesn’t advance during spin, 1min forev

The drain pump kicks in fine and empties before the spin so there doesn’t seem to be much water in there.

How sensitive are the pressure switches. A fairly gentle blow advances it when it is stuck on spin. People seem to say they are the last thing to go wrong?

As I type I’m doing a wash with no spin to see what happens. Seems fine so far. and I just heard the pump kick in.

[osc]

Re: Bosch Exxcel WVT1260GB/01 – stuck on 1 minute – heater i

It was a dry joint on the board – ran a soldering iron across the major joints, reassembled and all is 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}.

Thanks to all that helped, especially appliancefix82 who mentioned this in a previous post with an explanation of what is going on with the long cycle time.

washing-machine-forum/bosch-wvt1260-not-rinsing-draining-stuck-wash-mode-t83618.html

[osc]

Re: Bosch Exxcel WVT1260GB/01 – PCB replacement or repair

It was a dry joint on the board – ran a soldering iron across the major joints, reassembled and all is 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}.

Thanks to all that helped, especially appliancefix82 who mentioned this in a previous post with an explanation of what is going on with the long cycle time.

washing-machine-forum/bosch-wvt1260-not-rinsing-draining-stuck-wash-mode-t83618.html

[osc]

Re: Bosch Exxcel WVT1260GB/01 – stuck on 1 minute – heater i

thanks for the link. I’ve run a soldering iron over most of the joints on the PCB – hoping it’s a dry joint since I could find any component that looked damaged. It’s running a cycle now so fingers crossed.

[osc]

Re: Bosch Exxcel WVT1260GB/01 – PCB replacement or repair

Thanks, it was a good machine but not that good! Might try and find a local repair company – any ideas on here? I wouldn’t normally bother, but the rest of the machine is very clean and it will save it from the landfill.

[osc]

Re: Bosch Exxcel WVT1260GB/01 – stuck on 1 minute – heater i

Hi i just stripped the bottom end, and the drain pump spins free and operates on 240v as it should.

The pcb has a soot mark around a couple of components on the component side.

Is there somewhere I can get the board repaired, or a replacement?

[Author]

Posts