pbutterworth

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Zanussi WDJ1294 Door Gasket issue #202168
    pbutterworth
    Participant

    Is it likely that it is just the gasket causing my issues? I asume it’s hard to tell, but is it usual for these to fail and crumble?

    in reply to: SMEG UK STX2 Problems #179453
    pbutterworth
    Participant

    Re: SMEG UK STX2 Problems

    Yeah i worked that out too eventually, the grey cells are a little rusty!

    This looks more like it.

    http://www.dollymixtures.org/capacitor2.jpg

    It’s only got two wires though, any more clues?

    Thanks

    Paul

    in reply to: SMEG UK STX2 Problems #179451
    pbutterworth
    Participant

    Re: SMEG UK STX2 Problems

    Dave,

    Thanks for the prompt response. Having a look underneath, there is one obvious capacitor next to what I assume is the circulation motor.

    It’s some sort of dual capacitor that I dont remember from my electronics A Level!

    It’s a 0.1uF dual, is this likely to be the beast?

    A photo of the capacitor can be seen here:
    http://www.dollymixtures.org/capacitor.jpg

    My multimeter has died, but i’ll go to maplin & buy a new one if it’s likely to save a call out charge!

    Thanks
    Paul

    in reply to: Bosch Fridge Freezer KGV2604 Faulty #163738
    pbutterworth
    Participant

    Re: Bosch Fridge Freezer KGV2604 Faulty

    I was hoping for an idea of a repair or part replacement I can do myself, without having to call an engineer.

    It’s about 8-9 years old, so I dont want to spend too much on it!

    Thanks

    Paul

Viewing 4 posts - 1 through 4 (of 4 total)