Forum Replies Created
-
Posts
-
Success! I hope! The manual below has my controller on it so i have reset the user parameters, not going to mess with the installer ones atm. What would you recommend as the best setpoint temp? The manual says 35° so I’m guessing that’s F. I’m assuming fridge is set to °C as it hasn’t gotten especially cold yet. 9IS54460 – nEW 961-971-971 SPDT-974 NA EN 0317.pdf n
Have tried following a reset video on u tube that starts with holding in the set button and the turning on, so I held in the set button before I plugged it in but the figures did not correspond.
No it does not have a power button. It has touch sensitive buttons and the one at the top right is just a round light. It comes on when you plug it in.
Hi, I have found out it is an eliwell controller, but was custom made and discontinued so they can’t help. Can you advise me if I bought a similar eliwell control are they easy to swap and do they come pre set? Thank you.
Have tried resetting as per instructions by pressing up and down arrows for 6 secs but has not had the desired result. Has thrown up a new set of combinations 🙁
Tried that then pressed down arrow got c1, in, ul, t6, y8 then down to y4 by pressing down arrow. Pressing up arrow made all lights flash?
Hi thank you for your prompt reply. I have sent a link which should show you some photos.
