[PDF]

Re: F & P MW059NZ – blown control board??

Thanks for all your help guys. Fitted a new RPS tonight and it seems to be working fine. Fingers crossed it stays that way!

[PDF]

Re: F & P MW059NZ – blown control board??

Ok, RPS wiring measures .8ohm on all wires. Wiring and RPS looks good, no sign of water or corrosion etc. How do I check the oob and lid switches e.g what resistance am I looking for? I had a quick search of the forum but couldn’t find any values.

[PDF]

Re: F & P MW059NZ – blown control board??

Ok, so I replaced the cold solenoid and fitted a new controller board and the machine works again but after about 30sec faults 10000011. As far as I can tell this is the rotor position sensor. Is there anything specific that could cause this? I’m guessing (hoping) the board won’t be doing it. I have leaned the machine back a couple of times to get at the pump etc but the wiring appears to be ok.

Also, when I advance the cycle to spin the pump runs normally for a short time then starts working in very short bursts, before the rps fault appears. If I manually override it it works fine. Could the rps cause the pump to run erratically?

thanks again
Richard

[PDF]

Re: F & P MW059NZ – blown control board??

Thanks for the answers guys.

Yep the cold water inlet coil (solenoid) is cracked, but still reads 61.5 ohms. Is this likely to be the problem??

[Author]

Posts