[Petecam]

Re: Hotpoint WMA13 Issue going direct to spin and then stops

Hi Iadom

I measured the tacho cables from the PCB, open circuit.

After closer inspection I found a broken wire on the loom to the motor, it was pin 2 which is the tacho! Crimped it back together and all is well.

Not only have you helped save me getting a new machine you have saved one going to the tip.

Many thanks and a virtual pint to you sir.

Have a good weekend.

Cheers
Pete

[Petecam]

Re: Hotpoint WMA13 Issue going direct to spin and then stops

Hi Iadom

I did check the plug when I looked at the brushes. Will check the harness.

I have plenty of switch gear cable so I could run my own up just to test.

thanks again
Pete

[Author]

Posts