Forum Replies Created
-
Posts
-
Re: Dishwasher heater control
Thanks again. Off on holiday tomorrow so have 3 weeks away so will order it on my return.
Re: Dishwasher heater control
Martin am I right in that the thermostat is called a NTC unit? Or is that some thing else. Just looking at prices. Cheers. Paul
Re: Dishwasher heater control
just to clarify on prewash it goes to 0 and stops, its on the full wash it keeps running and showing 1?hope that makes sense? drain pump is brand new as well/
thanks again.
Re: Dishwasher heater control
Forgot to try that. Just ran it and it does indeed stop on prewash. Only keeps running on the main programme. Hope this means something thanks again for all your help. Paul.
Re: Dishwasher heater control
Thanks for that Dave. Not sure which way to go now bit frustrated we with it. Thanks for your reply.
Paul
Re: Dishwasher heater control
Ran the machine pressure seems fine as also ran it with no arms fitted. Still sits on the 1 point and runs for ever at that stage. Unless someone has a brainstorm of an idea. It’s either the bin or get an engineer in. Any one know of a cheap engineer in the Fareham Hampshire area? Hate being beaten by a machine. 😥
Re: Dishwasher heater control
Thanks guys I’ll try that next. in the morning. Fed up washing by hand Now.
Re: Dishwasher heater control
Looks ok to me. But am starting to run out of things to check really. Thanks as always for advice.
Re: Dishwasher heater control
Hi guys here again to pick your brains. The pics above show the only problems I could see on the board but looks odd. The top pic shows the rear of the PCB and the next the actual component. It looks to me as though the shown pin has never been soldered in but I could be wrong. Is this the timer component it looks like a little tranny to me? And help on this ongoing saga appreciated. Thanks. Paul.
Re: Dishwasher heater control
Thanks Martin. It didn’t want to go when I started I must have missed a latch the bottom bit stays on the facia I guess. ?
Re: Dishwasher heater control
Hi people have got to the control PCB as shown it looks like it just splits into 2 half’s. if some one gets the time to answer can you just confirm the plastic cover just splits into two as I don’t want to force any thing.
Re: Dishwasher heater control
That’s brill Dave. Thanks for all that info. Odd about the information not being allowed out by Bosch. Use to tell my engineers no drawings quote for new ones. Thanks again.
Paul.Re: Dishwasher heater control
Ok on to the PCB it is then. Is it all surface mount stuff or plug in?Any particular thing to look for bearing in mind I have no drawings. Bit odd for me to have nothing to refer to in fault finding. Thanks again for your help.
