[qwer]

My problem is I’ve unscrewed panel yet can’t fully remove it because part of the plastic facia is attached to the panel. I’ve tried gently pulling but fear breaking the plastic. Anyadvice how to remove please? stuart

[qwer]

Not on any external upload sites. Tried reducing the size of the image to 16kb and I keep getting told I’ve run out of upload quota despite not actually posting an image!

[qwer]

I’ll upload tomorrow stuart

[qwer]

Rapid wash (40 mins) as an example 20 mins in pause light comes on and so do red salt/rinse aid leds. The machine just hangs no heat the programme does not finish. Stuart

[qwer]

Water just over the bottom of the filter. I took a panel off no water in base the clear plastics had some water in them. The only program that runs correctly is the prewash. stuart

[qwer]

Not too much you can see it with filter out not sure out but I can have another look Tuesday

[qwer]

Yeah wrong word used but water is in coming stops after a fews minutes but the machine remains paused and salt/rinse aid lights are flashing.

[qwer]

You know where the filters are housed the water drains out there. stuart

[qwer]

I cleaned out bars they were not too bad. However I did not know how to access sump area is it via the side panel? I also noticed when it’s on a mid cycle drain pause if I open the door this continues. If I remove filters as this is happening water is jetting into the drain hole is this normal? Thx

[qwer]

Will do. Won’t be opening up machine til next Sat is easy to access motors? I never thought blocked cleaning bars would cause a continuing drain cycle. I’ll let you know how I get on next Sat thanks for your help have a good weekend. Stuart

[qwer]

The bars? I cleared the filters and what I could see in the drain hole. Cheers

[qwer]

Thanks I will try. Btw It’s my mum’s machine the filter was full of food the fine filter was full of grease and the drain hole had pieces of plastic wrapping in it! Could that have caused leaking?

[Author]

Posts